|
Shower Drain Connectors
|
Shower Drain Connectors
connect 2" DWV plastic, Schedule 40 steel or X.H. (extra-heavy) cast iron pipe to shower drain
bodies. They reduce the time and cost on installation because no special tools, gluing, threading, or
lead caulking are required.
|
Fernco Shower Drain Connectors will connect 2" DWV plastic,
schedule 40 steel or extra heavy cast iron to the following shower drain bodies:
|
|
Shower Drain Bodies
|
Use Fernco Part No.
When Ordering
|
|
American Brass & Aluminum
|
SD 200
|
|
Armstrong (Requires Cutting To ¾" Height)
|
SD 200
|
|
Casper-Mod. 101-101P (Without Internal Threading Boss) (See Detail 1 & 2)
|
SD 200
|
|
Casper-Mod. 101 BR (With Internal Threading Boss)
(See Detail 1 & 3)
|
SD 200
|
|
Garvin Mod. 475
|
SD 200
|
|
Intercon
|
SD 200
|
|
Kohler
|
SD 200
|
|
Mustee 1-Piece Molded Shower Base
|
SD 210
|
|
Owens Corning 1-Piece Molded Shower Base
|
SD 210
|
|
Schaul Mfg. Brass Mod. 1524
|
SD 200
|
|
Packaged for counter display with complete application and installation instructions.
|
|
Installation Instructions:
- Cut drain pipe to extend 1¼" into drain body.* Drain pipe should be even with top
of gasket when installation is completed. Position shower base over 2" waste pipe making sure
that pipe is centered in drain body.
- Lubricate gasket with soap solution and stretch over 2" pipe with letters facing up.
- Push gasket as far as possible into joint.
- Using hammer and caulking tool or 1¼" x ¾" x 6" piece of wood
instead of a caulking tool, work around gasket with a series of blows until it bottoms. Drain
pipe should be even with top of gasket.
- Test connection before covering or concealing. To test, plug 2" drain and fill receptor
with water. Check for leaks.
- If gasket installs by pushing into place with hand force only, the gasket is not compressed
and will leak.
*Except Armstrong
|
|
|
