Menu
Laundry standpipes
Hose Grip Washer Connector
Keeps the washer drain hose in the standpipe, so it can’t work its way out and spill water on the floor.
1½″ or 2″ standpipe
1″ to 1-7/16″ hose
Four vents
Made in USA
Keep the hose in the pipe
A washer pumps out a lot of water fast. That push can move a loose drain hose until it pops out of the standpipe. The Hose Grip clamps onto the top of the standpipe and holds the hose where it belongs.
Holds the hose
The tapered center grips washer drain hoses from 1″ to 1-7/16″
Four vents
Let air move during the washer’s discharge, so the hose isn’t sealed in
Clamps on
A stainless steel band holds it on a 1½″ or 2″ standpipe
Vented, not sealed
Air still moves. Four vents around the center let air flow while the washer drains, and the hose stays put.
1½″ or 2″
One part fits either standpipe.
No glue
No glue, primer or caulk. Tighten the clamp with a screwdriver or nut driver.
Neater than tape
Replaces zip ties and duct tape on the standpipe.
Fits most hoses
Washer drain hoses from 1″ to 1-7/16″.
HG-1
Hose Grip Washer Connector
One part for both standpipes. Fits a 1½″ or 2″ standpipe and washer drain hoses from 1″ to 1-7/16″.
- Holds the hose in the standpipe
- Four vents for air flow
- Flexible PVC with a stainless steel clamp
- Made in USA
- Also sold on a retail card as PHG-1
Four steps
1
Slide it on
Loosen the clamp and slide the Hose Grip over the top of the standpipe.
2
Tighten
Hand tighten the clamp with a screwdriver or nut driver.
3
Add the hose
Push the drain hose through the center to the depth your washer’s instructions call for.
4
Test
Run a drain cycle and check that the hose stays put and nothing leaks.
Specifications
| Part | HG-1 Hose Grip Washer Connector (retail card: PHG-1) |
| Standpipe | 1½″ or 2″ |
| Washer hose | 1″ to 1-7/16″ |
| Vents | 4 |
| Material | Flexible PVC |
| Clamp | Stainless steel |
| Max temperature | 120°F |
| Height | 1.5″ |
| Case quantity | 20 |
| Made in | USA |
Common questions
Will it fit my washer hose?
It fits most washer drain hoses from 1″ to 1-7/16″ across the outside. Not sure? Reach out.
Does it seal the hose into the standpipe?
No. It holds the hose in place, and four vents around the center let air move while the washer drains.
How far should the hose go in?
Follow your washer’s installation instructions. Washer makers set a limit on how far the hose goes into the standpipe.
Will it stop a standpipe from overflowing?
No. If water backs up out of the standpipe, the drain is slow or clogged. Clear the drain first.
Is there room behind my washer?
The Hose Grip adds a little to the outside of the standpipe, and the clamp screw sticks out to one side. Turn the screw away from the washer before you tighten it.
Got questions?
Not sure it fits your standpipe or hose? Our team can help. Reach out, or find your Fernco rep.